After frustratingly going around from hardware store to hardware store (Lowes and Home Depot) I have finally found the solution to my parts dilemma. Instead of trying to fit 1 1/4 pipe into a threaded coupler I hammered out that said coupler and put in one that was not female. BING! The pipe fits in perfectly. I need to go locate one tomorrow then assemble and seal the gun. After that I will fix the schrader valve by drilling a new hole and adding a new cap (this time sealed). After a few hours the gun should be ready for testing. I will use my dads camera for any video!
-Rob
-Rob
No comments:
Post a Comment